Salt Remover Kit w/Applicator

Directions

TO REMOVE SALT DEPOSITS FROM EXTERIOR MARINE SURFACES
Fill dispenser with concentrate. Attach one end of applicator to a garden hose and the other end to a trigger-type watering nozzle. Ensure blue knob is in the “Mixture” position, then turn black knob to “On” position. Thoroughly saturate all surfaces that need to be treated, allowing Salt Remover to soak in for 5 to 10 minutes. Stubborn deposits may require light brushing. Rinse with fresh water and allow to air dry.

TO TREAT ITEMS BY IMMERSING
Add approximately 1 fl. oz. (30 ml) of Salt Remover Concentrate per 32 fl. oz. (1 L) of fresh water. Immerse item to be treated for several minutes, rinse with fresh water and allow to air dry.

TO FLUSH INBOARD AND OUTBOARD ENGINES
Fill dispenser cup with Salt Remover Concentrate. Attach one end of applicator to a garden hose and the other end to a flushing unit designed for your engine type. Ensure blue knob is in the “Water Only” position, then turn the black knob to “On”. Run the engine to reach normal operating temperature. Once operating temperature has been reached, turn off the engine and the blue knob to “mixture” and verify solution is flowing. Restart engine and allow to run until dispenser cup is clear, and product has been used up. The Salt Remover PTEF® coating will protect the engine against future rust and corrosion.

TO CREATE A READY-TO-USE FORMULA IN A SPRAY BOTTLE
Add 1 fl. oz. (30 ml) Salt Remover Concentrate for every 32 oz. (quart) bottle capacity, then add water to fill bottle.

NOTE: Do not store Salt Remover in applicator when not in use.